Operation Mode
VYou can setup different modes to LAN and WLAN interface for NAT and bridging function.
*** WARNING: Do not forget to apply changes after making modifications! ***
Gateway:
In this mode, the device is supposed to connect to internet via ethernet port. The NAT is enabled and PCs in LAN ports share the same IP to ISP through WAN port. The connection type can be setup in WAN page by using PPPOE, DHCP client, PPTP client or static IP.
Bridge:
In this mode, all ethernet ports and wireless interface are bridged together and NAT function is disabled. All the WAN related function and firewall are not supported.
WISP Client:
In this mode, all ethernet ports are bridged together and the wireless client will connect to ISP access point. The NAT is enabled and PCs in ethernet ports share the same IP to ISP through wireless LAN. You must set the wireless to client mode first and connect to the ISP AP in Site-Survey page. The connection type can be setup in WAN page by using PPPOE, DHCP client, PPTP client or static IP.
Router (WAN Ethernet):
In this mode, the device is supposed to connect to internet via ethernet port and it will act as router. NAT system will be disabled.
Router (WAN Wireless):
In this mode, the device is supposed to connect to internet via Wireless port and it will act as router. NAT system will be disabled.