IP/MAC/Interface Traffic Control
 NOTE: Interface control has priority over IP/MAC. If you intend to use IP/MAC traffic control, you must disable interface control.
When in BRIDGE operation mode, inteface eth1 will be considered as WAN.

*** WARNING: Do not forget to apply changes after making modifications! ***


Interface Traffic Control Enabled   Disabled
LAN Output Rate kbps
WAN Output Rate kbps
  
  Enable QoS Group
Group ID LAN Out Rate WAN Out Rate Comment
kbps kbps
Current Group Table:
Group LAN Rate (Kbps) WAN Rate (Kbps) Comment Select

      
  Enable IP control
  Enable Firewall (Only listed IP/MAC clients will be allowed to passthrough)
Group ID* IP LAN Out Rate** WAN Out Rate** Comment
kbps kbps

**Put 0 if does not belong to any specific group
**When inside a group, it's considered as the minimum rate for the member. For equal sharing, put 0
Current IP control table:
Group IP Addr LAN Rate (Kbps) WAN Rate (Kbps) Comment Select

      
  Enable MAC control
Group ID*

MAC

 LAN Out Rate** WAN Out Rate** Comment
kbps kbps

*Put 0 if does not belong to any specific group
**When inside a group, it's considered as the minimum rate for the member. For equal sharing, put 0
Current MAC control table:
Group MAC Addr LAN Rate (Kbps) WAN Rate (Kbps) Comment Select